In a variety of industries and technical fields, most of the industrial catch related to the practice of operational requirements to design. In addition to the majority of mechanical grip made into two claw type or three claw type, also often choose vacuum grab. There are two fundamental layout methods in the manual rule, that is, integrated layout and modular layout.

When you choose a modular layout, all of the row-process programs required for movement are installed in the palm and finger database. In this way, the hand can get used to the wanton operation of organizing or finishing the movement of weaving. Another characteristic is that the size of the parts of the robot manipulator is large, and most of these artificial hands are significantly larger than those of the human hand.

High-quality manipulator accessories can greatly extend the service life of the manipulator, can fix and improve the quality of the injection molding goods, and prevent the loss of the mechanical arm accessories caused by human error. The effect of injection manipulator in injection molding production is becoming more and more important. Nowadays, the type of manipulator in China is simple to measure, and it is mostly used for picking up parts.

This is to manually open the adsorption switch and apply paper to the sucker. Manipulator accessories to see how much practical adsorption pressure, if in the normal scale, it is still in question. If the suction pressure does not go up, it is where the trachea leak. Azimuth, right, but no way out. You have to check if the sucker has broken, and some of the suckers form cracks and then leak. Do not replace the new sucker on the adsorption pressure.

Relax the pull-out cylinder stabilizer and slide into the arm so that it is close to the arch. Slide the manipulator fitting seat so that it is close to the arm. Pull the cylinder firmly so that the arm won't slide

Lock the rotary safety screw so that the manipulator can not swing. Arrange the sundries in the worktable and the equipment, wash the guide rail of the injection seat with clean cotton and some pulling rods of the table. (remove sundries) check equipment control switches, buttons, electrical wiring, operating handle, handwheel for any damage or failure appearance. The switch and handle of the manipulator fittings should be in the position of "broken", and the fittings (check the opening and closing) should see whether the screws in each part are tightened or loosened, and if they find the parts abnormal or have the appearance of damage, they should state to the foreman. The foreman disposed of himself or told the repairman to dispose of it